Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

The electrical resistance of Thermoelectric generator

英 李 Certified Consultant

Please login with a confirmed email address before reporting spam

I have built a simple thermoelectric generator(TEG) with one P leg and one N leg connecting to a external load resistance through the "Electrical circuit". After setting material type, the hot and cold side temperature, I did a parameter sweep on external load resistance Re to get the maximum output power of the TEG. Theorectically, the external load resistance Re corresponding to the maximum output power should be equal to the internal electrical resistance of the TEG. However, the Re corresponding to the maximum output power from the simulation is always larger than the internal electrical resistance of the calculation results( which is the sum of electrical resistances of copper electrodes and TE legs), see the attached picture. Could someone explain why this happens? Many thanks~



0 Replies Last Post 2022年5月10日 GMT-4 09:52
COMSOL Moderator

Hello 英 李

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.