Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric Sweep Parameters Are In One List Instead Of Multiple?

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


In case someone has the same issue and cannot figure out the reason: this may happen when there are empty solution for some values of sweep parameters, e.g. the solver could not find any eigenmodes. Adjust the solver settings to make sure it returns at least one solution at each step and the problem is gone.

Best regards!


0 Replies Last Post 2023年4月17日 GMT-4 21:44
COMSOL Moderator

Hello Anton Dyshlyuk

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.