Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Manual Meshing??

Posted 2010年2月17日 GMT-5 06:19 0 Replies

Mohammed Abdul Hadi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
i imported the model in comsol from Orcad.... and now when i try to initialise the mesh it gives an error 4029.. and when i insert few point after that it shows an error decomposing structure.... Can anyone suggest a sollution for this...

i read in this forum about maual meshing!! How should i do this..... can some one help me out....

Regards.
0 Replies Last Post 2010年2月17日 GMT-5 06:19
COMSOL Moderator

Hello Mohammed Abdul Hadi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content