Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Event interface to control ohmic heating (electric current)
Posted 2023年8月1日 GMT-4 14:02 RF & Microwave Engineering, Heat Transfer, Physics Interfaces Version 5.6 0 Replies
Please login with a confirmed email address before reporting spam
I am modeling an ohmic heating of food and I want to add an event interface to control the heater (electric current) to stop when center temperature in the food is above 70 ͦC by 0.5 ͦC and continue when center temperature is below 70 ͦC by 0.5 ͦC. I tried to follow the steps in this blog: https://www.comsol.com/blogs/implementing-a-thermostat-with-the-events-interface/#goto-comments
However, I think I am missing something. In the example above, for the thermostat, qtot = 1[W]HeaterState. In my case, what and where should I specify such an equation?
I have attached screen for my interface and the example.
Thank you
Hello arguani
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.