Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to continuously apply boundary loads in transient studies

Posted 2024年1月17日 GMT-5 04:38 Structural & Acoustics, Studies & Solvers 1 Reply

x wang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I defined a boundary load (solid mechanics module) on the inner wall of the model. However, in transient studies, the defined boundary load exists only at t=0. I want it to last forever. What should I do?

I want to use this model of applied internal pressure for transient studies, such as studying the propagation of sound waves under different internal pressures

Attachments:

1 Reply Last Post 2024年1月17日 GMT-5 12:43
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 months ago 2024年1月17日 GMT-5 12:43

If you set a constant value it will remain constant for all times.

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
If you set a constant value it will remain constant for all times.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content