Parametric Sweep Interpolation Results

Please login with a confirmed email address before reporting spam

Hello,

I have run a tensile test parametric sweep where the sample is strained to 80% nominal strain at a rate of 10% strain per second in a time-dependent calculation. I would like to create a plot showing the strain at which each curve crosses the 5 kPa stress mark.

I believe this might involve using an interpolation function, but I am unsure about the exact syntax or setup. When I run a boundary probe for stress, the output table contains columns for modulus (μ), time, and stress. I am not sure how to extract the specific strain values corresponding to the 5 kPa stress from this table for each corresponding modulus sweep.

Would a parametric curve approach work better, or is there a way to process the probe results directly to get what I need?

Attached is the result from my simulation.



Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.