Heat a block between parallel copper plate

Please login with a confirmed email address before reporting spam

Hello experts,

I am trying to heat a block (bone) between parallel copper plate. The plate is 5 cm in diameter and 0.2 cm in height. The block dimension 1x1x0.2 cm. I read a research paper who solved similar problem (attached). They mentioned using EM Waves, frequency domain and heat transfer modules. For the power input 100 W for 50 ohm impedance. Peak voltage input 100 V. They also mentioned using lumped port. Which surface should I select as lump port? Should I select uniform lump port? How can I solve the problem based on your opinion? Source file attached. Thanks in advance.



Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.