Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problems Converting .mph to .m
Posted 2013年2月26日 GMT-5 11:30 Fluid & Heat, Interfacing, Computational Fluid Dynamics (CFD), Geometry Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I am working within the fluid-structure interaction module in COMSOL. I would like to vary one of my geometric parameters to optimize a design, and as you all know, COMSOL with MATLAB is the best place to do this. My problem is this, specifically:
When I 'Save as Model-M File' and open up that file in MATLAB, much to my surprise I find all my parameters to be different than what I have saved in my original COMSOL file! This is not limited to different fluid velocities at the inlet, but also inclues completely altering my geometry that I have specified in the original model.
Does anyone have any inkling as to why COMSOL is doing this? It is obviously very frustrating, and I am pretty new with the interface so I am lost as to what is happening here.
Thanks for your help!
Hello Ben Paxson
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.