Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Permanent magnet and iron block

Posted 2025年5月6日 GMT+8 14:17 Electromagnetics Version 6.1 4 Replies

Alex Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone. I wanna use Comsol to calculate the magnetic force of an iron block (L1W1H1) under the influence of a permanent magnet (L2W2H2), and their distance change from 2cm to 3cm. How can I achieve this? Many thanks.

4 Replies Last Post 2025年5月21日 GMT+8 15:19
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2025年5月7日 GMT+8 18:16

https://www.comsol.com/model/permanent-magnet-78

https://www.comsol.com/model/permanent-magnet-78
Alex Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2025年5月21日 GMT+8 12:11

https://www.comsol.com/model/permanent-magnet-78

Thanks for your reply. I have tried this example. However, it always unable to converge.

>https://www.comsol.com/model/permanent-magnet-78 Thanks for your reply. I have tried this example. However, it always unable to converge.
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2025年5月21日 GMT+8 14:36

I tried it too and it converges in seconds.

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
I tried it too and it converges in seconds.
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2025年5月21日 GMT+8 15:19

If you post your model then we might be able to troubleshoot, but if the instructions have been followed in the example above, it should work just fine.

If you post your model then we might be able to troubleshoot, but if the instructions have been followed in the example above, it should work just fine.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content