Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

element quadrilateral quadratic 8 nodes

Posted 2013年3月8日 GMT-5 20:06 Mesh Version 4.2a 1 Reply

Vera Ferreira
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

How can i to do a mesh with element quadrilateral quadratic 8 nodes?

Thanks!

1 Reply Last Post 2013年3月9日 GMT-5 04:29
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年3月9日 GMT-5 04:29
Hi

you mean blocks ? tra y mapped aud mesh on asurface, and then sweep the mesh in the other direction.
Note that sweep mesh is slightly tricky, and have some limiting requirements on the topology of the lateral (sweep length) sides, these have to be identical

This implies often that you need to cut up your geometry into many blocks, by adding internal boundaries

--
Good luck
Ivar
Hi you mean blocks ? tra y mapped aud mesh on asurface, and then sweep the mesh in the other direction. Note that sweep mesh is slightly tricky, and have some limiting requirements on the topology of the lateral (sweep length) sides, these have to be identical This implies often that you need to cut up your geometry into many blocks, by adding internal boundaries -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content