SAW Delay Line Simulation with Large Number of IDT Pairs

Please login with a confirmed email address before reporting spam

Hello,

I am trying to simulate a SAW delay line device in COMSOL with 100 IDT pairs on each side (input and output). Since modeling the full geometry with all these pairs would be very large and computationally expensive, I tried to simplify the model.

Currently, I built the geometry with only one IDT pair and applied periodic boundary conditions on both lateral sides of the device, assuming that this would mimic the effect of multiple pairs.

However, I am not sure if this approach is physically correct for a delay line with so many electrodes. Also, the results I am getting contain a lot of noise, which makes me wonder if my simplification is not valid.

My questions are:

Is it physically correct to model only one IDT pair with periodic conditions to represent many pairs in a SAW delay line?

Are there better approaches in COMSOL to simulate a large number of IDTs (e.g., 100 pairs per side) without building the full geometry explicitly?

Could the noise I observe be related to this simplification?

Any guidance or references would be very helpful.

Thank you!


1 Reply Last Post 2025年8月26日 GMT+8 22:54
Edgar J. Kaiser Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 3 hours ago 2025年8月26日 GMT+8 22:54

A single IDT pair with periodic BC behaves like an assembly with an infinitely large number of pairs. I don't see how this would represent a delay line. To simplify things consider to do it in 2D instead of 3D. You can also consider to start with a smaller number of pairs and stepwise increase the number to see if it converges some way for larger numbers.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
A single IDT pair with periodic BC behaves like an assembly with an infinitely large number of pairs. I don't see how this would represent a delay line. To simplify things consider to do it in 2D instead of 3D. You can also consider to start with a smaller number of pairs and stepwise increase the number to see if it converges some way for larger numbers. Cheers Edgar

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.