Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Combining different variables into one
Posted 2013年7月9日 GMT-4 04:38 Low-Frequency Electromagnetics, Heat Transfer & Phase Change Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello all, i am quite new in the COMSOL world so i dont know all the possibilities that go with it and i would like to know if somebody can tell me how to combine expressions for different time steps in time dependent problems into one.
for example i want to use a smoothed step function from 0 to t1 and then from t1 to t2 a cosine function, so similar like the IF and ELSEIF operators in MATLAB. so again, form 0 to t1 i need to use one expression and from t2 to t3 another.
thank you in advance :)
for example i want to use a smoothed step function from 0 to t1 and then from t1 to t2 a cosine function, so similar like the IF and ELSEIF operators in MATLAB. so again, form 0 to t1 i need to use one expression and from t2 to t3 another.
thank you in advance :)
1 Reply Last Post 2013年7月11日 GMT-4 04:22
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
You can use an "if" function directly in COMSOL when defining a variable, material property, or PDE coefficient, for example:
if(t<t1,step1(t),cos(t))
means that COMSOL will use step1(t) (a smoothed step function that you have added to the model) from the simulation start time up until t1 and then switch to cos(t) (the cosine function, which is a built-in mathematical function). t1 is typically defined as a parameter.
You can also use a Boolean expression:
step1(t)*(t<t1)+cos(t)*(t>=t1)
which is equivalent, and can be expanded to additional "time segments." You may want to call the functions using t[1/s] to make the input unitless.
Best regards,
Magnus Ringh, COMSOL
You can use an "if" function directly in COMSOL when defining a variable, material property, or PDE coefficient, for example:
if(t<t1,step1(t),cos(t))
means that COMSOL will use step1(t) (a smoothed step function that you have added to the model) from the simulation start time up until t1 and then switch to cos(t) (the cosine function, which is a built-in mathematical function). t1 is typically defined as a parameter.
You can also use a Boolean expression:
step1(t)*(t<t1)+cos(t)*(t>=t1)
which is equivalent, and can be expanded to additional "time segments." You may want to call the functions using t[1/s] to make the input unitless.
Best regards,
Magnus Ringh, COMSOL