Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Changing parameter during time-dependent study with MATLAB (Does not work at specific time)
Posted 2013年8月18日 GMT-4 17:57 Interfacing Version 4.2a 0 Replies
Please login with a confirmed email address before reporting spam
I have a script running using MATLAB livelink. It is a time-dependent study and I would like to change the parameters defined at specific time during the study.
I have managed to make this work by setting the following in a for loop script:
time_specified=80
if 't'>=time specified
model.param.set('Tchamber',293.15);
end
The problem that I am facing now is if the time specified is more than 100 s, the parameter would not change during the study. I tested several studies to pin point this time "limit".
I am unsure if the time range has any effects on this matter but the stop time for the study was more than 300 s and the time step was 1 s. The parameters specified in the mph file are as follows:
Tsub 873.15[K]
Tdep 1723.15[K]
hdep 650[W/(m^2*K)]
hsub 55[W/(m^2*K)]
period 60[s]
dt 1[s]
t0 0
tf t0+period
Tchamber 523[K]
Any inputs are appreciated.
Best regards,
Charles
Hello Charles Selfridges
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.