Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Model coupling to 2D to 3D geomety (General Extrusion)
Posted 2013年8月21日 GMT-4 23:27 Fluid & Heat Version 4.3 0 Replies
Please login with a confirmed email address before reporting spam
I want to do a model coupling of 2D geometry and 3D.
For this i used general extrusion coupling for that.
I want to couple outlet ( along y axis) and inlet boundaries of 3D geometry through general extrusion coupling method. both geometries are of rectangle shapes.
I could not find suitable expressions for x and y in destination map in general extrusion couplings.
can anyone figure out equations of x and y in destination map for general extrusion coupling.??/
i have attached figure with this message.
looking forward for a reply
regards
Ali
Attachments:
Hello Ali
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.