Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Drawing hollow cylinders

Posted 2013年10月22日 GMT-4 15:40 Geometry Version 4.3 1 Reply

Joey Dumont
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi!

I am trying to draw concentric hollow cylinders. That is, I have a central cylinder and then concentric cylinders around that central one. How does one do that?

Thank you,
1 Reply Last Post 2013年10月22日 GMT-4 15:49
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年10月22日 GMT-4 15:49
Joey-

See attached *.mph file.

--
Best regards,
Josh Thomas
AltaSim Technologies
Joey- See attached *.mph file. -- Best regards, Josh Thomas AltaSim Technologies

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content