Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Surface discharge

Posted 2013年10月31日 GMT-4 01:08 2 Replies

Nadezda Starikova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I’m modeling wire (conductor&insulation). Conductor is grounded. High voltage is applied in the point on the insulation surface. Is it possible to simulate the surface discharge? If it is possible, how to do it?

Thanks!
2 Replies Last Post 2013年10月31日 GMT-4 23:09
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年10月31日 GMT-4 06:27
Nadezda,

with the AC/DC module you can obtain the electrical field strength and see if it exceeds the breakdown field strength of the material anywhere in the geometry. You cannot model the dielectric breakdown itself and you need to know the breakdown fieldstrength of your material from literature or measurement.

Cheers
Edgar

--
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Nadezda, with the AC/DC module you can obtain the electrical field strength and see if it exceeds the breakdown field strength of the material anywhere in the geometry. You cannot model the dielectric breakdown itself and you need to know the breakdown fieldstrength of your material from literature or measurement. Cheers Edgar -- Edgar J. Kaiser emPhys Physical Technology http://www.emphys.com
Nadezda Starikova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年10月31日 GMT-4 23:09
Thank you for your help!
Thank you for your help!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content