Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
eigenfrequency of the tilting plate.
Posted 2014年1月21日 GMT-5 23:13 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I was tring to model a square plate tilting about the center line with the squeeze film damping effect. I build two tiny beams to connected the square plate, make sure the plate can rotate about these two symmetric beams. And also the two tiny beams can supply the tosional stiffness. But, I just need to simulate the eigenfrequency of the tilting plate without the calculation of the connected beams. The problem is:
1, How can I seperate the connected beams in the eigenfrequency calculation?
2, Is there a better way to supply the tosional stiffness without bulid the connected beams?
3, I already set the square plate as a rigid domain using Rigid Connector. But when I changed the Young's modulus of the plate, the eigenfrequency is still changed? I really confused. Could you tell me why? Or the model is not right.
The model what I already build is attached, does somebody know this kind of problem, please give me some advise, thank you very much
I was tring to model a square plate tilting about the center line with the squeeze film damping effect. I build two tiny beams to connected the square plate, make sure the plate can rotate about these two symmetric beams. And also the two tiny beams can supply the tosional stiffness. But, I just need to simulate the eigenfrequency of the tilting plate without the calculation of the connected beams. The problem is:
1, How can I seperate the connected beams in the eigenfrequency calculation?
2, Is there a better way to supply the tosional stiffness without bulid the connected beams?
3, I already set the square plate as a rigid domain using Rigid Connector. But when I changed the Young's modulus of the plate, the eigenfrequency is still changed? I really confused. Could you tell me why? Or the model is not right.
The model what I already build is attached, does somebody know this kind of problem, please give me some advise, thank you very much
1 Reply Last Post 2014年1月21日 GMT-5 23:14
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Sorry, I forget to attach the file.
Attachments: