Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Fluid flow and heat transfer in heat exchanger

Posted 2014年2月5日 GMT-5 13:11 Fluid & Heat, Heat Transfer & Phase Change Version 4.2a 2 Replies

Vinay Patel
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I am solving a conduction- convection heat transfer problem with 2 dimensional in shell and tube heat exchanger.

Problem Description are as:
The size of inner radius of tube is 6mm. and
outer radius of shell size 12mm.
Now from the inner tube heat transfer fluid is flowing with velocity of 15m/s with constant temperature , (say 200°C).
Whereas, in the shell there is solid phase change material with melting temperature of 34°C.

I put all the thermophysical properties of phase change material as well as heat transfer fluid.

And run the simulation for 6h. but results are not obtained?

The following results i want to check: 1) how the heat transfer takes place from heat transfer fluid to phase change material ( i.e. conduction and convection)

2) At what time the convection will start?

3) I am using fluid thermal interaction module of non-isothermal flow. whether it is correct? or I have to used another module.

Please suggest me how to solve the above problem or give me some guidelines so that I can solve the problem.

Thanking you .

Sincerely,
Vinay Patel.
2 Replies Last Post 2014年2月5日 GMT-5 13:55
Patcharapit Promoppatum
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年2月5日 GMT-5 13:41
Hi,

I used to have similar problems. Since your velocity is very high. You might try to reduce to lower velocity and see if the model is converging. Moreover, you might use step function to ramp your flow at beginning so in this case you could avoid shock flow.
In order to check your model, you might also consider disable the properties of PCM at the beginning and use some other built in material to save the computation time.

Hope this help!
Joe
Hi, I used to have similar problems. Since your velocity is very high. You might try to reduce to lower velocity and see if the model is converging. Moreover, you might use step function to ramp your flow at beginning so in this case you could avoid shock flow. In order to check your model, you might also consider disable the properties of PCM at the beginning and use some other built in material to save the computation time. Hope this help! Joe
Vinay Patel
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年2月5日 GMT-5 13:55
Dear Sir,

Thank you for your valuable suggestion.

I will put the lower value of flow velocity and use other material instead of PCM.

I will reply to you.

Thanking you,

Sincerely,

Vinay Patel
Dear Sir, Thank you for your valuable suggestion. I will put the lower value of flow velocity and use other material instead of PCM. I will reply to you. Thanking you, Sincerely, Vinay Patel

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content