Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Multi turn coil printed on a polyimid flex PCB.

Posted 2014年2月14日 GMT-5 10:06 Low-Frequency Electromagnetics Version 4.4 0 Replies

Mehdi Ayadi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I need to display magnetic field lines generated by a multi turn (8) coil printed on a polyimid flex PCB. The coil has a rectangle shape 333mm x 41mm. The copper layer has a thinkness of 0.035mm. The coil has two terminals connected to a sinus wave generator and to ground.

Could you please explain, how is the best way to modelize it on COMSOL.

Thanks.

Attachments:

0 Replies Last Post 2014年2月14日 GMT-5 10:06
COMSOL Moderator

Hello Mehdi Ayadi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content