Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Extremely high local stress maxima in static analyses
Posted 2014年3月25日 GMT-4 08:11 Mesh, Results & Visualization, Studies & Solvers, Structural Mechanics Version 4.3b 0 Replies
Please login with a confirmed email address before reporting spam
//
Problem was solved by the comsol support. The meshes on the two sides didn't match each other, which caused these unplausible results.
//
i'm experiencing a problem with a quite simple static analysis in comsol multiphysics.
In attachement 1 you can see the geometry of the model, which consists of two plates (aluminium) that are only connected in the circular areas.
In attachement 2+3 the mesh and the mesh statistics are shown, which are quite ok. A finer mesh is not possible, because of limitations in computational power. The mesh is a free tetrahedral mesh for the whole geometry.
loads and boundaries:
*Prescribed Displacement (x) of 0.005mm at the end of each plate (opposed directions)
*Prescribed displacement of 0mm in y and z direction at the end of each plate
*Symmetry (y-Directions)
*Continuity in each circular area
Solver:
MUMPS Solver with standard settings. Have tried PARDISO, which makes no difference to the result, but is a bit faster.
Results:
The deformation plot (Attachement 4) looks plausible. The stress plot (Attachement 5) shows circular stress distributions araound every contact area, which is also plausible, but it also shows very high, randomly distributed maxima around the contact areas which is not plausible for me.
Are there any ideas how to solve this problem? It seems to be a problem with the mesh, but it happened with different mesh sizes and parameters too.
Thanks for your help!
(The MPH File is in Attachement 6, if someone wants to take a closer look)
Attachments:
Hello Martin Zöltsch
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.