Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

problem in comsol program

Please login with a confirmed email address before reporting spam

Hi comsolers,

I defined two projects in comsol in 2D for solving richards equation:
first project: simple rectangle that left boundary was defined as pressure head=0.8 and right boundary as pressure head=0.5, the other two angles= zero flux
and then I made a cross section from these two points from 0.8 to 0.5 (attached cross section as picture1).

Second project: simple rectangle that left boundary was defined as step function for the pressure head from zero to 0.8 =0.8 and from 0.8 to 1.4=0, and for the right boundary pressure head was defined from zero to 0.5=0.5 and from 0.5 to 1.4= 0; the two other angles were zero flux.( attached plots for the left and right boundary as left and right boundary)
Expected results= that cross section for second project for pressure head from 0.8 to 0.5 should be the same as first project.(attached as cross section sample)

Comsol results=they are not like each other!!!!

Do you have any idea that what is the problem in comsol?
Thanks in advance for your valuable comments.
Sepideh


0 Replies Last Post 2014年3月28日 GMT-4 05:01
COMSOL Moderator

Hello Sepideh Ramezani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.