Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mixture of sweep mesh+Tetrahedral mesh in a 3D model
Posted 2014年3月30日 GMT-4 00:28 Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers 2 Replies
Please login with a confirmed email address before reporting spam
I have a helical coil embedded in solid cylinder and was trying to figure out best way to mesh it since helix always creates problems.
1)I did a mapped mesh on one end of coil cross section.
2)Swept it along the coil, till the destination face.
3)I meshed the cylinder with tetrahedral mesh.
I am always getting errors. The model is just not meshing. I tried meshing complete model with tets and it did mesh after a looong time, but it gave error while solving.
Would really appreciate if someone could give some guidance.
Thanks
1)I did a mapped mesh on one end of coil cross section.
2)Swept it along the coil, till the destination face.
3)I meshed the cylinder with tetrahedral mesh.
I am always getting errors. The model is just not meshing. I tried meshing complete model with tets and it did mesh after a looong time, but it gave error while solving.
Would really appreciate if someone could give some guidance.
Thanks
2 Replies Last Post 2016年7月20日 GMT-4 09:15
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
If you could upload your model I could have a look at it.
If you could upload your model I could have a look at it.
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Did anyone have solved a similar problem? Because I too have done swept mesh in some part of my model and then wanted tets model for the rest of the model. It dosents mesh.