Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
File import/export procedure: Not reading whole data
Posted 2014年4月2日 GMT-4 02:39 Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers, Structural Mechanics 0 Replies
Please login with a confirmed email address before reporting spam
I am using:
1- Global Definitions --- Interpolation --- import file
2- Structural module ---- Thermal expansion--- int1(x,y,z) as Temperature load ---- Reference Temperature= 0
However, after solving the Time-Dependent problem, when I plot the Temperature in" Results": It shows only first entry / value of temperature of the imported file i.e. no gradient at all or not matching with interpolated values plot.. When I plot the interpolation: it shows the right plotting of T(x,y,z)
Can someone tell me why it is not being imposing as gradient? Because, I am not getting the expected stresses. The result of stress value is very low than expected.
Hello Nazir Hina
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.