Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
un-smooth output Heat Flux caused by solver oder BC?
Posted 2014年5月9日 GMT-4 05:37 1 Reply
Please login with a confirmed email address before reporting spam
Hi All,
i'm having problem to get heat flux that comes out of PMSM smooth. A slice of PMSM produce loss evenly(BC Heat source) for example at winding (to simplify the problem, only on winding). Most of heat goes on water cooling that placed outside of stator. The heat flux (ntflux) is evaluated using surface intergral on outer boundary of stator.
it's a time dependent model and has about 1 million mesh (no warnings). All material properties are constant (non temperature-dependent).
On attached screen shots are the accumulated heat flux from all outer boundary divide by input of heat source. So the max. result should be 1.
to get the heat flux curve smooth i've tried to set the relative tolerance at 1e-8, using very small time step or "force" the solver time step as small as the result (strickt). And exclude algebraic.
Now i'm trying to change the solver setting and hope that the result be better. Every ideas are welcome.
best regards
Akmal
i'm having problem to get heat flux that comes out of PMSM smooth. A slice of PMSM produce loss evenly(BC Heat source) for example at winding (to simplify the problem, only on winding). Most of heat goes on water cooling that placed outside of stator. The heat flux (ntflux) is evaluated using surface intergral on outer boundary of stator.
it's a time dependent model and has about 1 million mesh (no warnings). All material properties are constant (non temperature-dependent).
On attached screen shots are the accumulated heat flux from all outer boundary divide by input of heat source. So the max. result should be 1.
to get the heat flux curve smooth i've tried to set the relative tolerance at 1e-8, using very small time step or "force" the solver time step as small as the result (strickt). And exclude algebraic.
Now i'm trying to change the solver setting and hope that the result be better. Every ideas are welcome.
best regards
Akmal
Attachments:
1 Reply Last Post 2014年5月23日 GMT-4 07:04
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
it solved using weak constrais on fixed temperature boundary, where heat flux is calculated.
www.comsol.de/support/knowledgebase/973/
regards
it solved using weak constrais on fixed temperature boundary, where heat flux is calculated.
www.comsol.de/support/knowledgebase/973/
regards