Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Residual stresses analyses of thermal spray process by COMSOL (birth and death unit)
Posted 2014年9月16日 GMT-4 04:54 Modeling Tools & Definitions, Structural Mechanics Version 4.3b 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate a thermal spray coating process, with COMSOL Multyphycis v4.3b.
My model is a multiple-layerAl2O3 gradient coating on AL substrate. I use a 2D geometry.
2 steps are needed to simulate the deposition of each layer :
- deposition of the coating layer
- cooling-down
The coating is composed of 10 layers.
In the previous study, Mr.Alexis Grenier has used 10 solver to solve each layers, and he uses the final temperature of layer N as initial temperature of layer N + 1 .it works, but it is very complicated for the whole process, I would like to know if there are easier ways to solve this problem? such as birth and death unit?
Thanks for your help!
Hello Duo Yi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.