Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Simulating capacitive device operating at collapse voltage
Posted 2014年9月24日 GMT-4 01:29 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers, Structural Mechanics Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate an capacitive ultrasound transducer operating at collapse voltage. The model, made of two parallel capacitor plates, are expected to collapse into each other during simulation, then its eigenfrequencies are to be calculated. Is this possible with COMSOL? If not, would it work if I start the simulation using an already collapsed model?
Thanks,
Sergei
Hello Sergei Dmitriyev
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.