Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Nodes and element labels
Posted 2010年5月12日 GMT-4 09:52 1 Reply
Please login with a confirmed email address before reporting spam
How can I get a mesh wich shows elements and nodes labels?
1 Reply Last Post 2010年5月12日 GMT-4 16:20
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
here to I beleive you must use matlab, as normally in COMSOL (this is different from other tools, ps note that) you do not work on the mesh but on the geometry for defining your boundary conditions (BC's).
The mesh is a later "add-on" that gets its properties by inheretance depending on which analysed geometric entity it belongs to.
The node and edge labels, as well as surface/boundaries and subdomain/volume labels are "analysed geoemtry" based.
perhaps one way is to mesh and then save the mesh as a geometry, check the "mesh" menu
Good luck
Ivar
here to I beleive you must use matlab, as normally in COMSOL (this is different from other tools, ps note that) you do not work on the mesh but on the geometry for defining your boundary conditions (BC's).
The mesh is a later "add-on" that gets its properties by inheretance depending on which analysed geometric entity it belongs to.
The node and edge labels, as well as surface/boundaries and subdomain/volume labels are "analysed geoemtry" based.
perhaps one way is to mesh and then save the mesh as a geometry, check the "mesh" menu
Good luck
Ivar