Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
ultrasonic testing of steel by normal probe- wall echo
Posted 2015年1月16日 GMT-5 02:12 Acoustics & Vibrations, Geometry, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers, Structural Mechanics 0 Replies
Please login with a confirmed email address before reporting spam
I am trying to simulate ultrasonic testing of steel by normal probe. A 2D model was built. The probe is defined as Lead Zirconate Titanate(PZT-5H) and generates a sine wave to the steel. Is there any problem with setting of boundary conditions? If the calculation is right, here are some questions.
Firstly, how can I get the plot which shows ultrasound near-far field (similar to attached figure 1) and the plot which shows beam pattern(similar to attached figure 2) ?
Secondly, how can I get the information about signal of wall echo (including the receiving time and amplitude of signal) ? In this ultrasonic testing, the probe generates incident wave and also works as receiver to obtain the wall echo.
Thank you very much.
Attachments:
Hello Jing Wang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.