Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Exporting figures and data files in cluster batch job

Posted 2015年3月3日 GMT-5 09:10 Version 4.4 0 Replies

Juergen Hansmann
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I have a Matlab model file that I run on a cluster.
When starting comsolserver directly with: "comsolserver matlab -np 8 -graphics" all plots and data files are generated.

Starting comsolserver with mpiexec and using comsolclusterbatch and then loggin in with mphstart later on from Matlab will cause that NO data files and plots are generetad, using exactly the same .m file.

Did anyone experience something like this and find a solution?

Thanks a lot for any hints.
Best regards,
Juergen
0 Replies Last Post 2015年3月3日 GMT-5 09:10
COMSOL Moderator

Hello Juergen Hansmann

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content