Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Deformed mesh problem - tracking descending interface in a reaction tank

Please login with a confirmed email address before reporting spam

Hi all,

I am trying to use deformed mesh to track a descending interface in a reaction tank. Please see the attached figure.

The tank consists of a porous electrode and filled with electrolyte originally. The electrolyte level keeps decreasing because of reaction. The exposed electrode is filled with air. To simplify the problem, now I set a prescribed constant velocity to the interface. The boundary grids are sliding on y direction accordingly. x-direction velocity of all the interfaces are set to be zero. Ideally the liquid/air interface would move downward and keep a straight line. However, the results shows unwanted deformation on x-direction and the moving velocity of grids on the interface become a function of x. I have tried different smoothing methods but still cannot get the expected results. Any tips would be helpful, thanks!


0 Replies Last Post 2015年3月22日 GMT-4 20:23
COMSOL Moderator

Hello Jing Huang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.