Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

solving two partial differential equations nonlinear in comsol?

Posted 2015年4月3日 GMT-4 10:04 Heat Transfer & Phase Change, Materials, Studies & Solvers Version 4.2 3 Replies

Cong-Truc Vu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I want to solve two pde nonlinear with two variables (please find in the attachment file) with the constants.

For solve, i tried to use the heat equation and PDE (c) in two step:
step 1: solve PDE(c) only
step 2: solve two equations with the step 1 results

Unfortunately, the results weren't changed anything if i change the constants.

Are you see this problem?
3 Replies Last Post 2017年4月5日 GMT-4 20:12
Myungwu Woo
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 2015年4月3日 GMT-4 17:11
I am wondering "Density" and "Heat Capacity at constant pressure" of "Heat Transfer in Solids 1" could be any non zero values.

Regards,
I am wondering "Density" and "Heat Capacity at constant pressure" of "Heat Transfer in Solids 1" could be any non zero values. Regards,
Cong-Truc Vu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 2015年4月3日 GMT-4 18:52
Thanks for your attention, @myungwu woo. Because this is the stationary case, so these values doesn't impact in the solution. Best regards,
Thanks for your attention, @myungwu woo. Because this is the stationary case, so these values doesn't impact in the solution. Best regards,
MdAminul Islam
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年4月5日 GMT-4 20:12
As I am new to comsol I want to ask a question about the simulation you did. Why did you use steps in the solver? I know that without this I can not get any solution but how should I know that I need to put steps to get the solution.

Thanks
As I am new to comsol I want to ask a question about the simulation you did. Why did you use steps in the solver? I know that without this I can not get any solution but how should I know that I need to put steps to get the solution. Thanks

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content