Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to find pressure drop in a micro rectangular pipe(silicon) ?

Please login with a confirmed email address before reporting spam

I am new to COMSOL. I have to find the pressure drop. The parameters are width is 0.3mm and the length of the pipe is 40mm. The liquid is water and the inlet pressure is for example 100bar. i had designed the pipe and given the inlet pressure but couldn't find the pressure drop at the outlet. can someone help me out and let me know what and where i am doing wrong ?

Thanks in advance!!!

1 Reply Last Post 2015年12月4日 GMT-5 17:13
COMSOL Moderator

Hello Ramanathan Meyyappan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年12月4日 GMT-5 17:13
Hello Ramanathan,
Typically these kinds of models are set up by specifying a velocity profile (or flow rate) at the inlet and setting the outlet to a gauge pressure. When the model's run, the difference between the pressure at the inlet and the pressure at the outlet is your pressure drop.
Best,
Jeff
Hello Ramanathan, Typically these kinds of models are set up by specifying a velocity profile (or flow rate) at the inlet and setting the outlet to a gauge pressure. When the model's run, the difference between the pressure at the inlet and the pressure at the outlet is your pressure drop. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.