Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parameter Sweep Study then Time-Dependent Follow Up

Posted 2015年10月20日 GMT-4 05:52 Low-Frequency Electromagnetics Version 4.4 0 Replies

James Creel
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I have a study that must be calculated in stationary mode (Study 1). I do a parameter sweep to add a time component (I know how my input parameters vary with time and they relate linearly to the stationary input variables). I would like to use that parametric study to feed into a time dependent study (Study 2), where each time step corresponds to the next parametric output in the parametric Study 1.

So far, I haven't been able to figure this out. Any ideas?
0 Replies Last Post 2015年10月20日 GMT-4 05:52
COMSOL Moderator

Hello James Creel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content