Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

laser heating simulation

Posted 2015年11月18日 GMT-5 11:59 Heat Transfer & Phase Change Version 5.1 1 Reply

Sean Petzold
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am new to Comsol. I need equations that model a laser. The model should be gaussian in regards to heat flux. Then the laser would move across a flat 3D surface. The final step is to use these equations in MATLAB to simulate Selective Laser Sintering.
1 Reply Last Post 2015年11月18日 GMT-5 14:02
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年11月18日 GMT-5 14:02
This model may be a good starting point for you:
www.comsol.com/model/laser-heating-of-a-silicon-wafer-13835
Hope it helps.
Jeff
This model may be a good starting point for you: http://www.comsol.com/model/laser-heating-of-a-silicon-wafer-13835 Hope it helps. Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content