Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Initial condition during simulation corrosion process
Posted 2015年12月18日 GMT-5 16:31 Electrochemistry 0 Replies
Please login with a confirmed email address before reporting spam
I am using the Tertiary current distribution of corrosion module to simulate the pitting corrosion process. I found that the initial values of the Electrolyte potential (phil) and Electric potential (phis) had great effects on the convergence of calculation.
If I set the Eeq, phil and phis 0, the model converged very quickly. However, when I set the Eeq for my anode reaction with a specific value, and left the phil and phis with 0, the model could't converge.
My question is how should I set the initial value of phil and phis?
Thank you very much!
Regards
Zhe
Hello Zhe Zhang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.