Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to plot the Excess Pore Pressure

Posted 2016年3月4日 GMT-5 11:39 Porous Media Flow 0 Replies

Giulia M.
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

I'm implementing a simple reservoir model in 2D, with two layers with different permeability. The fluid is continuously pumped out at a constant flow rate.
I need to plot the "Excess pore pressure". Any idea about how I could do it? Is there a specific command in COMSOL? I've found that "poro.pm" should be the Total pressure, but the results of the Excess pore pressure (pex = ptot - p hydro) are not what I've been expected.

Thank you very much for your help.

Giulia
0 Replies Last Post 2016年3月4日 GMT-5 11:39
COMSOL Moderator

Hello Giulia M.

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content