Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Constraints for bending an asymmetrically deformed block
Posted 2016年11月15日 GMT-5 12:53 Heat Transfer & Phase Change, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Structural Mechanics Version 5.2 0 Replies
Please login with a confirmed email address before reporting spam
I was hoping for some input/ideas regarding the proper constraints necessary for bending a block that is asymetrically deformed. I would like to apply edge loads to either side of the block and then be able to bend either one side or both using these edge loads in order to restore the block as close as possible to it's undeformed state. Currently, I am using symmetric boundary conditions but these interfere too much and make the model non-realistic. For instance, if I bend one side of the block and I have a symmetry condition in the middle, the other side of the block is effected much less and I get a bump in my data where the symmetry condition is. Are there any ways in which I can more delicately hold these kinds of things in place without having a hard interference somewhere? Any info is greatly appreciated. Thank you.
Hello Nicholas Goldring
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.