Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Electric circuit with piezo sensor

Please login with a confirmed email address before reporting spam

Good Day,

I'm doing a design on comsol software, my project consists on connecting the output of piezoelectric sensor to an electric resistor. The disgn and simulation of the sensor has been done, now I want to connect the output of this sensor with an electric resistor. I would be gratful if you could advise if is't possible to do that or not? if so, how could I do this. Thank you

Best regards

1 Reply Last Post 2011年2月4日 GMT-5 08:13
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年2月4日 GMT-5 08:13
Hi

if it is a "lumped item" you could try to connect up a SPICE model (see the doc) or if its a "physical FEM model, you must define it and then link the two with corresponding variables/equations

--
Good luck
Ivar
Hi if it is a "lumped item" you could try to connect up a SPICE model (see the doc) or if its a "physical FEM model, you must define it and then link the two with corresponding variables/equations -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.