Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

moving melt

Posted 2011年3月11日 GMT-5 16:56 RF & Microwave Engineering, Fluid & Heat, Heat Transfer & Phase Change, Mesh Version 4.0a 0 Replies

Navid Asadiznajani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
I want to simulate melt in cavity like an injection molding process. I do not want to exactly do properties of melt I want to simulate melt as a thin box which goes into another box and acts like a melt. so important things are

first: how to move melt box into the other one and consider temperature changes for both boxes.
actually I have done it using parametric sweep tool of comsol but in this case simulation is done in each step independent to the last step so temperature contours are not related to the previous one.

second I want to consider radiation which I think will not be as difficult as the first one, using surface to surface radiation tool may work.

thanks
0 Replies Last Post 2011年3月11日 GMT-5 16:56
COMSOL Moderator

Hello Navid Asadiznajani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content