Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Joule heating using terminal
Posted 2017年9月5日 GMT-4 03:52 Low-Frequency Electromagnetics, Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.3 1 Reply
Please login with a confirmed email address before reporting spam
Hello.
I'm trying to simulate the process of plasma-plasma sintering.
To set the heating rate, I model the PID controller with the input current at the upper boundary using the terminal.
But the resultant current at all points of the model is the same, which is incorrect.
What's my mistake?
I added a link to the model file, because I can not attach a file here.
yadi.sk/d/_DdnVw1t3McJo7
I'm trying to simulate the process of plasma-plasma sintering.
To set the heating rate, I model the PID controller with the input current at the upper boundary using the terminal.
But the resultant current at all points of the model is the same, which is incorrect.
What's my mistake?
I added a link to the model file, because I can not attach a file here.
yadi.sk/d/_DdnVw1t3McJo7
1 Reply Last Post 2017年9月12日 GMT-4 02:26
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Nikita,
I computed your model, and the current density is not uniform in the domain. May be you should adjust Range limits in the Plot Settings to see the current distribution in the domain. See picture attached.
--
Best regards,
Dmitrii L.
I computed your model, and the current density is not uniform in the domain. May be you should adjust Range limits in the Plot Settings to see the current distribution in the domain. See picture attached.
--
Best regards,
Dmitrii L.
Attachments: