Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with contact

Posted 2017年12月1日 GMT-5 04:15 Structural & Acoustics Version 5.0 0 Replies

Fiorella Riccio
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I have a problem with this system: I have 3 elements, the upper one is a silicone membrane, the middle one is a piston and the lower one is a sample. I have a gap of 1mm between the membrane and the piston. I want to apply pressure on the surface of the membrane and observe how the sample deforms. I created two pairs of contact, one between the membrane and the piston and one between the piston and the sample. When I start the analysis, however, I get this error:Maximum number of Newton iterations reached

What's the problem? can someone help me? Thanks

0 Replies Last Post 2017年12月1日 GMT-5 04:15
COMSOL Moderator

Hello Fiorella Riccio

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content