Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing units of probe variable

Posted 2017年12月19日 GMT+8 19:56 Results & Visualization Version 5.3a 3 Replies

Robert Low
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a heat conduction model running and I have put a probe at the centre of my domain so I can track temperature. It keeps reverting to Kelvin for the units of temperature - and the resulting data table and plot graph are also in Kelvin. I'd like it in degC, and have set the units to be degC. However whenever the solver runs it reverts to K. What dumb mistake am I making?

3 Replies Last Post 2018年1月25日 GMT+8 16:52
Gunnar Andersson COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年12月19日 GMT+8 21:41

I tested this in a simple heat transfer model but was unable to reproduce the behavior that you saw. Can you upload the model or send it to COMSOL Support?

I tested this in a simple heat transfer model but was unable to reproduce the behavior that you saw. Can you upload the model or send it to COMSOL Support?
Robert Low
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年12月20日 GMT+8 00:16

Gunnar, I'll send it to Comsol support. I'd rather not upload the file to the public discussion.

Gunnar, I'll send it to Comsol support. I'd rather not upload the file to the public discussion.
Kerry Leith
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2018年1月25日 GMT+8 16:52

Hi,

I had a similar problem. The output used to be in degC, since lost it's unit in the probe table. I solved the issue by clearing the result, deleting the table, getting the initial solution for the study step, and then selecting one of the probes in the definition table and updating the solution.

Hi, I had a similar problem. The output used to be in degC, since lost it's unit in the probe table. I solved the issue by clearing the result, deleting the table, getting the initial solution for the study step, and then selecting one of the probes in the definition table and updating the solution.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content