Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
monitor the internal temperature field for a 3D heat transfer model ?
Posted 2011年4月5日 GMT-4 14:22 Parameters, Variables, & Functions, Results & Visualization Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
A 3D heat transfer model, cooled from outside to inside. I want to know the position (coordinates) of the point whose temperature is reduced the most slowly (I check the plot while solving box, but I cannot see the internal temperature field), how should I do? Can "probe" do this? Thank you!
1 Reply Last Post 2011年4月6日 GMT-4 01:37
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I would say make a section cut on your Data set and identify the max or min of the gradient, then with the dual name calling of the max operator you might get out the coordinates. (you can get it directly in the 3D domain, but its not "visible" for a plot if you do not cut your domain somehow) you can also use the coordinates identification of the value found in the domain to identify the right plane where to cut
--
Good luck
Ivar
I would say make a section cut on your Data set and identify the max or min of the gradient, then with the dual name calling of the max operator you might get out the coordinates. (you can get it directly in the 3D domain, but its not "visible" for a plot if you do not cut your domain somehow) you can also use the coordinates identification of the value found in the domain to identify the right plane where to cut
--
Good luck
Ivar