Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Regarding Microresistor beam example in COMSOL Multiphysics 4.0a

Posted 2011年4月6日 GMT-4 07:35 1 Reply

Jean F
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I had a question regarding microresistor beam example in MEMS module:


Copper is used in this example. Can aluminium be used in microresistor beam ?
Are there any advantages or disadvantages if we use aluminium instead of copper?

Please provide me an answer for this.

Thank you
1 Reply Last Post 2011年4月6日 GMT-4 09:24
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年4月6日 GMT-4 09:24
Hi

what are you looking for ? the resistivity ? then check the material data, idem for stiffness and heat capacity properties.

But the main reason I believe is a technological reason, from my knowledge it's easier to deposit Cu than Al, either electrochemically or via soldering

--
Good luck
Ivar
Hi what are you looking for ? the resistivity ? then check the material data, idem for stiffness and heat capacity properties. But the main reason I believe is a technological reason, from my knowledge it's easier to deposit Cu than Al, either electrochemically or via soldering -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content