Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Turning off automatic remeshing in parametric sweep

Posted 2011年5月30日 GMT-4 09:31 Mesh Version 4.1 2 Replies

Juergen Hansmann
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

is it possible to turn off the automatic remeshing for every step in a parametric sweep run?
I would like to only create the mesh once in the beginning and use the same mesh for every step of the parametric sweep.
This would save a lot of time and also elements..

Thanks a lot and best regards,
Juergen
2 Replies Last Post 2011年5月30日 GMT-4 11:16
Edgar Kaiser
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年5月30日 GMT-4 10:53
Hi,

I am doing parametric frequency response studies and didn't observe remeshing from step to step. Is your parameter some way affecting geometry or the mesh specifications?

Cheers
Edgar
Hi, I am doing parametric frequency response studies and didn't observe remeshing from step to step. Is your parameter some way affecting geometry or the mesh specifications? Cheers Edgar
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年5月30日 GMT-4 11:16
Hi

Then use the Study Extension Continuation Sweep and not an Explicit Parametric Sweep (the latter runs through the mesher), and you should perhaps turn of the default "automatic mesher" and convert it to a user mesh

--
Good luck
Ivar
Hi Then use the Study Extension Continuation Sweep and not an Explicit Parametric Sweep (the latter runs through the mesher), and you should perhaps turn of the default "automatic mesher" and convert it to a user mesh -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content