Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Boundary Condition for Coefficient form PDE
Posted 2018年10月1日 GMT-4 08:20 Structural & Acoustics, General, Equation-Based Modeling Version 5.1 0 Replies
Please login with a confirmed email address before reporting spam
Hello, I am using the Coefficient form of PDE and I need to set a boundary at a concentration value of 1[mg/cm^3].
When the simulation runs, This concentration will spread uniformly throughout the geometry.
I do not want the inlet boundary set at a constant concentration 1[mg/cm^3] it should reduce over time as the diffusion causes the concentration to be distributed evenly across the entire geometry.
I want to know how can I set the value to my boundary without using Dirichlet boundary conditions. Dirichlet boundary conditions will keep the value of concentration at the boundary constant. I do not want it constant. I want it reducing as it loses the mass due to diffusion towards region of lower concentration.
Hello Inayeth Ali
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.