Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

droplet volume decreasing, when I use two-phase flow Level set method.

Please login with a confirmed email address before reporting spam

Hello Everyone,

I am trying use two-phase flow level-set method to simulate droplet spreading on superhydrophobic surface. However, the droplet volume always decreasing after acheving equilibrium state.

Please share your experience/ thoughts/ suggestions about this.

Thanks in advance.

Qiang


0 Replies Last Post 2018年11月12日 GMT-5 02:59
COMSOL Moderator

Hello Qiang Wang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.