Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
basic problem with Rf modelling
Posted 2011年9月5日 GMT-4 01:43 1 Reply
Please login with a confirmed email address before reporting spam
Hi
I am just learning to use comsol..
so I was trying to run simulation for simple dielctric..
the error I get is
" feature : stationary solver 1(sol 1/s1)
error: empty parameter list. "
I was following the circulator model already in comsol for reference..
where there is nothing defined in parameter ..no frequence but still I defined taking care of the error.
still nothing.
I am using comsol 4.2.
I am just learning to use comsol..
so I was trying to run simulation for simple dielctric..
the error I get is
" feature : stationary solver 1(sol 1/s1)
error: empty parameter list. "
I was following the circulator model already in comsol for reference..
where there is nothing defined in parameter ..no frequence but still I defined taking care of the error.
still nothing.
I am using comsol 4.2.
1 Reply Last Post 2011年9月6日 GMT-4 02:07
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I suspect you have forgotten to define the frequency range in the solver node, check the doc or an example from the model lirary
--
Good luck
Ivar
I suspect you have forgotten to define the frequency range in the solver node, check the doc or an example from the model lirary
--
Good luck
Ivar