Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Proper Module/geometry to model fiber optic cable in comsol in soil layers

Please login with a confirmed email address before reporting spam

Hi,

I am new to comsol and I want to model a vertical Fiber Optic distributed temperature sensing (DTS) cable in soil layers, and then use the heat transfer module to get the temperature in different soil layers. I have started the modeling by simulating the DTS cable using a cylinder geometry. As you can imagine, the radius of the cable is very small (0.125 mm) as expected and the length is about 10 m. My question is: Is this the proper way to do this small scale modeling in comsol? Also, I don't have any electricity in my cable, a laser sends a pulse of light into the fiber to measure the temperature along the cable based on the difference in intensity of different scattered light in the cable.


0 Replies Last Post 2019年5月8日 GMT-4 13:03
COMSOL Moderator

Hello Maryam Ghadiri

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.