Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
thin long wire in RF
Posted 2011年10月30日 GMT-4 08:05 RF & Microwave Engineering Version 4.1 1 Reply
Please login with a confirmed email address before reporting spam
Dear all
I am trying to create a model with a very thin wire. The wire is supposed to be have a circular cross-section of 1 cm dia and be about 1000 m in length .
I need to excited wire with a (sinusoidal) current in the small segment and simulate the current along wire then calculate electromagnetic field around wire. I started with a RF in 3D, but I have problem in meshing and running the model.How I can mesh and run this model?
regards.
I am trying to create a model with a very thin wire. The wire is supposed to be have a circular cross-section of 1 cm dia and be about 1000 m in length .
I need to excited wire with a (sinusoidal) current in the small segment and simulate the current along wire then calculate electromagnetic field around wire. I started with a RF in 3D, but I have problem in meshing and running the model.How I can mesh and run this model?
regards.
Attachments:
1 Reply Last Post 2011年10月30日 GMT-4 08:39
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if you do not need to resolve the wire (internal info inside the wire) then use an edge current, its easier ;)
--
Good luck
Ivar
if you do not need to resolve the wire (internal info inside the wire) then use an edge current, its easier ;)
--
Good luck
Ivar